How do you clear a Zanussi error code?

How do you clear a Zanussi error code?

Step 1 Zanussi Washing Machine Fault Code Reset The lights ( or digital screen ) will flash – release the buttons (the lights should scroll). Now turn the dial a further 9 clicks clockwise. Note the error code displayed. Continue turning the dial clockwise till you get to off, then turn to any program and back to off.

Why is my Zanussi washing machine not working?

If the appliance is still dead, unplug the appliance again and check the fuse in the plug. If no method of checking the fuse exists, replace it with a known working 13 Amp fuse. Then try the appliance again.

What does E40 mean on a Zanussi washing machine?

An E40 error on a Zanussi washing machine points to a malfunctioning door. First, check if the door is properly closed. Make sure there is no laundry trapped between then washing machine and the door. If the washing machine is completely full, the problem might be that the drum is overloaded.

How do you open the door on a Zanussi washing machine?

You can open the door anytime during the delayed start. – Wait until the lock icon on your display switches off/you hear the door unlock. If this does not happen within 1 minute, you are too far into the cycle to open the door. -Close the door and press the Start/Pause button again to resume the cycle.

Where is the reset button on a Zanussi washing machine?

Resetting guide: Press the two buttons at the top (soak and pre-wash). At the same time, turn the cycle selector counter-clockwise to the delicate spin cycle. Then release the two buttons and continue turning the selector counter-clockwise all the way round to off (almost one full turn).

How do you fix an e20 error on a Zanussi washing machine?

Resolution

1. Ensure the drain hose is in the correct position.
2. Ensure correct drain height.
3. Clean the pump and filter.
4. Check for a blocked drain.
5. Check the drainage hose for possible kink or twist.
6. Use less soap powder.
7. Switch off the power to the washing machine.
8. Contact an Authorised Service Center.

How do I reset my Zanussi washing machine?

Resetting guide: Press the two buttons at the top (soak and pre-wash). At the same time, turn the cycle selector counter-clockwise to the delicate spin cycle. Then release the two buttons and continue turning the selector counter-clockwise all the way round to off (almost one full turn). Try to wash normally.

Why is my washing still wet after spinning?

Overloading can lead to an imbalance that reduces the washer’s spin speed, leaving clothes too wet after spin cycle completes. If the washer leaves clothes soaked after a large load, remove some items, redistribute others and run another rinse and spin cycle.

How do I fix E40 error on Zanussi washing machine?

Resolution

1. Check if the door/lid is properly closed. If necessary, give the door/lid a firm push.
2. There is too much laundry in the machine (overload). If necessary, remove some laundry from the drum before restarting the cycle.
3. Check the mechanical child safety lock (if applicable).

What is E40 error in washing machine?

Cause: The appliance door / lid is open or not closed correctly. The appliance is overloaded. The door lock is faulty.

Why can’t I open my washing machine door?

The most common cause is water left in the machine. Try running a spin/drain cycle. If this fails, the machine can be drained by placing the washing machine drain hose lower than the drum (into a bucket or tray). The door interlock has simply jammed.