Where can I find a well log in Oregon?

Where can I find a well log in Oregon?

The Water Resources Department (WRD) has drilling records of most water wells drilled in Oregon since 1955. If there is a copy of your well log, you can find it using the WRD’s search program called GRID. You may also contact your local Watermaster for a copy of well logs and for help interpreting the information.

How do I find the old well on my property?

Clues to the location of these wells include:

  1. Pipes sticking out of the ground.
  2. Small buildings that may have been a well house.
  3. Depressions in the ground.
  4. The presence of concrete vaults or pits (perhaps covered by lumber or metal plates)
  5. Out-of-use windmills (wind pumps) are likely to be located near an old well.

Do you need a permit for a well in Oregon?

Under Oregon law, “all water within the state from all sources of water supply belongs to the public.” In general you must obtain a water right permit before using water from any well. However, there are exceptions called “exempt uses” (see ORS 537.545).

How do I find well depths in my area?

The USGS National Water Information System (NWIS) has depth-to-water measurements made in the present and the past. A convenient way to find data for your area is by using the NWIS Mapper and selecting “Groundwater Sites” in the menu on the left. Click on any red groundwater pin to access the data.

How do I find my well depth?

Measure from the bottom of the weight to the ground level mark on your string. This is the depth of your well.

How do you find underground water for a well?

In order to locate groundwater on your property, you need to get hold of a professional called a hydrologist. He will come to your land and inspect the property to see where the groundwater is located.

Can I dig my own well in Oregon?

However a property owner may construct their own well in the state of Oregon provided that they adhere to the rules outlined below. …

How deep is the average well in Oregon?

In the Medford area of Jackson County, springs discharge as much as 18,000 gallons per minute. Wells that are used for domestic and commercial and agricultural (primarily livestock watering) purposes generally are 40 to 145 feet deep. Depth to water ranges from less than 10 to about 15 feet below land surface.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top