What are the two temps high and low for a triple aquastat?

What are the two temps high and low for a triple aquastat?

The LO is set at 170º F, with the DIFF set at 15º F. The burner will come on at 160º F to maintain hot water, but it will shut off at 175º F because of the differential or DIFF setting of 15º F. The circulator can run for heat between 160º F and 175º F.

What is the aquastat on water heater?

The aquastat is a device that controls the temperature of the water inside the boiler – much as a thermostat does for the air inside the house.

What should aquastat be set at?

In most cases, the high-limit temperature setting on an aquastat should be between 180 and 200 degrees Fahrenheit. If the aquastat is set at 200 degrees Fahrenheit as the high-limit setting and the pressure valve begins to leak, set the temperature back to 195 degrees Fahrenheit.

How do I test my Honeywell aquastat?

How to Conduct Basic Boiler Aquastat Controller Tests:

1. Turn thermostat down – Turn the wall thermostat all the way down so it is not calling for heat.
2. Check incoming voltage –
3. Check the low voltage transformer output:
4. Check thermostat switch terminals:
5. Check burner power terminals:
6. Check circulator terminals:

What temperature should my aquastat be set at?

What should water heater temp be set at?

120 degrees Fahrenheit
120 degrees Fahrenheit is the safety recommendation against scalding, but 140° is the common default setting. Most experts agree that anything below 120 degrees creates a risk for bacteria to develop inside your water heater from stagnant water, such as legionella that causes Legionnaire’s disease.

What temp should I set my aquastat?

What is the best setting for my boiler?

As a rule, setting your heating control to 75 degrees should be sufficient to give you a perfectly warm house, while also allowing your boiler to run as economically as possible. Once this is set, you shouldn’t need to adjust it.

How do you hook up a Honeywell thermostat?

Thread the wires through the opening in the new Honeywell thermostat. Attach the thermostat’s wall plate to the wall with the provided anchors and screws.

How does a Honeywell aquastat work?

Aquastat is a Honeywell’s registered trademark and is a device used for temperature control in hydronic heating systems. High limit aquastats regulate boiler burners operation when thermostat call for heat. Low limit type aquatats are used with tankless coils to maintain water temperature inside the boiler outside the heating season (summer).

How does an aquastat work?

An aquastat is a device used in hydronic heating systems for controlling water temperature. To prevent the boiler from firing too often, aquastats have a high limit temperature and a low limit.