How much cupboard space does a Quooker tap need?
The tank is square. If you have specified a Flex tap please note we require at least 500mm deep x 200mm wide space below the tap position under the worktop in the cupboard. This is required to allow the weight that operates the Flex hose to move freely up and down.
How tall is Quooker tap?
What are the dimensions of the Quooker tank and tap? Installation
| The dimensions of the tanks are as follows: | ||
|---|---|---|
| For single taps: | ||
| PRO3-VAQ | COMBI | |
| Tank height: | 40cm | 47cm |
| Tank diameter: | 15cm | 20cm |
Where should a Quooker tap be placed?
The Fusion, Nordic mixer tap and Flex tap hole should be 35 mm in diameter. The Nordic single tap should ideally be positioned at the corner of the sink to enable use above the sink or the work top. Note: It must be possible to move the spout of the Nordic single tap freely up and down.
Does a Quooker use a lot of electricity?
What is the annual energy consumption of a Quooker COMBI? A Quooker COMBI consumes 511 kWh per year if warm water is used in accordance with the usage pattern defined in the regulations.
Does Quooker price include installation?
When you purchase any full Quooker system (tap and tank) at the full RRP, we will include installation by a dedicated Quooker engineer for £99 (usually £384).
How long does a Quooker take to heat up?
between 10 and 20 minutes
If the entire content of boiling water is used in one go, it takes between 10 and 20 minutes for the water to reach boiling temperature again, depending on the tank type. All Quooker taps are fitted with a childproof double-push-and-turn handle. A light ring lights up when the tap is dispensing water.
What wattage is a Quooker tap?
10 watts
Because a Quooker is fitted with high-vacuum insulation cladding, the energy loss, is only 10 watts.
Is it easy to fit a Quooker tap?
The Quooker comes with a handy installation kit (including the required inlet combination) for easy fitting, and is maintenance-free. The HiTAC® filter cartridge has to be replaced about once every five years, when any lime scale that has built is also removed from the tank.
What is Quooker VAQ E?
Introduction The operation of the Quooker VAQ E The Quooker system consists of a small tank under the sink which is connected to the Nordic single tap, the Fusion or the Flex tap. The tank is vacuum-insulated and is connected to the cold water supply via an inlet combination valve.
What is a Quooker system?
The Quooker system consists of a small tank under the sink which is connected to the Nordic single tap, the Fusion or the Flex tap. The tank is vacuum-insulated and is connected to the cold water supply via an inlet combination valve. Inside the tank the water is heated electrically to
What are the electrical requirements for the Quooker tank?
• The Quooker tank is supplied with a UK 3 pin plug and requires a standard 13 amp earthed socket. • If the mains lead is damaged it should be replaced by the manufacturer, their agent or a qualified technician to prevent hazard. • The light ring on the Nordic single tap, the Fusion or Flex tap will light up to indicate when the
How do I install a Quooker 3 3 2 4 Tap?
3 2 4 1. Connect the hoses Connect the hot water and cold water hoses on the tap. 2. Tap through work top Push the tap through the hole in the work top. 3. Securing tap Position the brass fixing plate around the hoses. Screw the fixing nut onto the tap thread. Adjust the position of the tap to ensure that the Quooker logo is facing the user.