How do I fix error 5b00 on Canon g2400?

How do I fix error 5b00 on Canon g2400?

I had the same issue and solved it this way.

1. Press and hold the power button (While connected to power)
2. Press the ‘cancel’ button SIX (6) TIMES.
3. Release all buttons.
4. Press ‘cancel’ button FIVE (5) Times.
5. Press the POWER button ONCE. (
6. Press the power button to turn off the printer then turn on again.
7. This worked for me.

How do I fix error code 5b00?

How to fix Canon printer error 5b00

1. Step 1: Unplug the device.
2. Step 2: Press down and continue to hold the power button of the printer and plug the power cord into the wall socket.
3. Step 3: Hold the power button until the printer starts resetting itself.
4. Step 4: Wait for the green power light in the printer to turn off.

What is error 5b00 in Canon printer?

The 5b00 error usually denotes a situation when a user cannot print due to the improper usage of the ink cartridge.

How do I reset my Canon Pixma iP2770 printer?

Hold down Resume button and press Power button. Keep holding down Power button and let Resume button go. Then Press Resume button 5 times then let BOTH buttons go. You will notice that the Alternate Blinking error is gone, this means that the printer is in Service Mode state.

How do I reset my Canon ink absorber full?

Press and hold the “Power” button and reconnect the power cord. When the printer comes on, release the button. Wait five seconds and push the “Power” button again. This resets the printer’s internal memory and overrides the “Ink Absorber Full” error code.

How do you fix a full ink absorber?

Why the ink absorber is full?

The error “Ink Absorber Full” means that the internal ink absorber or flushing box will need to be replaced. The need to replace these items and the time period before replacement is dependent on the number of purges and flushes required to clean the ink system.

How do I fix my Canon ink absorber?

How do I get my Canon printer to recognize refilled cartridges?

If your Canon printer isn’t recognising a compatible ink cartridge, this may be because the data on the cartridge chip is stamped with an empty status before it was remanufactured. Hold down the stop / cancel button for 5 seconds to bypass the ‘ink has run out’ message and your cartridge should work.

How do you clean a Canon ink absorber?

1. Take a bowl with warm water and add some soapy material.
2. Open the ink cartridge compartment.
3. wait for ink cartridges and disconnect the printers power cord.
4. Look balck rubber frame under the ink cartridge.
5. pull the rubber frame out of the printer and remove ink absorber pads.
6. clean the pads in the bowl.