How do I configure an ip address on ASA 5505?
Set a Static IP for your Cisco ASA5505 Firewall
- Open the ASDM and log into your device.
- Under Configuration, Interfaces, select the Outside interface and hit Edit.
- In the ‘IP Address’ box, click the radio for ‘Use Static IP’
- Select an IP address, and use ‘255.255.
- Hit ok, then apply.
Is Cisco ASA 5505 a switch?
The ASA 5505 supports a built-in switch. There are two kinds of ports and interfaces that you need to configure: Physical switch ports—The ASA has 8 Fast Ethernet switch ports that forward traffic at Layer 2, using the switching function in hardware.
How configure Cisco ASA 5505 firewall?
Cisco ASA 5505 configuration
- Step1: Configure the internal interface vlan.
- Step 2: Configure the external interface vlan (connected to Internet)
- Step 3: Assign Ethernet 0/0 to Vlan 2.
- Step 4: Enable the rest interfaces with no shut.
- Step 5: Configure PAT on the outside interface.
- Step 6: Configure default route.
How do I add a VLAN to my firewall?
Adding a VLAN interface
- Go to Network > Interfaces.
- Click Add Interface and then select Add VLAN. Note: The VLAN associated with an interface should be configured with the same IP (IPv4 or IPv6) family as the one used to configure the physical interface.
- Enter the following parameters:
- Click Save to add the VLAN.
How do I connect to ASA 5505?
Is Cisco ASA 5505 a router?
Note: If you purchase Cisco ASA 5505, please verify the package contents. The ASA is NOT a router, though and while you can do things on the ASA that can make it act something like a router it is important to understand the differences between true routing and what the ASA actually does.
What replaced the Cisco ASA 5505?
Cisco Introduces New ASA 5506/5508 to replace ASA 5505 SMB Firewall. Cisco is introducing a new line of ASAs to replace the existing SMB ASA 5505 line of firewalls.
How do I reset my Cisco ASA 5505 to factory settings?
- After you open connection, press enter a couple of times, and you should get a prompt like: ‘ciscoasa>’
- type ‘enable’ to go to enable mode.
- type ‘config t’
- type ‘config factory-default’
- hit spacebar when the ‘more’ is displayed.
- type ‘reload save-config noconfirm’
How configure Cisco ASA firewall?