What is Xscf?
Server monitoring and administration by Extended System Control Facility (XSCF) XSCF regularly monitors server components including CPU, memory, disks, fan rotation and device temperatures. Monitored information is stored in the XSCF.
How to check fault in XSCF?
Using the fmdump (8) Command to Confirm a Fault Perform the fmdump (8) command on the XSCF Shell and reference the log.
How do I prompt to console in SC?
About the sc> Prompt. About the ok Prompt. About Switching Between the ALOM System Controller and the System Console….To Enter the ok Prompt.
| Access Method | What to Do |
|---|---|
| Externally initiated reset (XIR) | From the sc> prompt, type the reset -x command. |
| Manual system reset | From the sc> prompt, type the reset command. |
How do I open SP console?
How To Access the System Console Remotely Using the ILOM CLI
- Establish an SSH connection using the following command, and then enter the default password (changeme) when you are prompted:
- To power on the system, type the command: start /SYS.
- To start the system console, type: start /SP/console.
How do I check the xscf event logs?
Establish a connection through the XSCF-LAN port, and use the XSCF Shell to check error logs and other information. See Appendix Bfor the corrective action. c. Otherwise, check the XSCF event logs and server status by using the XSCF Shell through the serial port.
How do I view temperature and humidity history logs in xscf?
The XSCF firmware collects the environment and temperature and humidity history regarding the server in a temperature and humidity log. The temperature and humidity history log is displayed at ten-minute intervals. Specify the envoption on the XSCF Shell and perform the showlogs(8) command to reference temperature and humidity history logs.
How to view Active Directory logs on xscf reset?
When the Active Directory authentication and authorization for users, the diagnostic messages are logged. This log is for use in troubleshooting and is cleared on XSCF reset. Specify the log option on the XSCF Shell and perform the showad(8) command to reference Active Directory logs.
How to use the showlogs (8) command to reference console logs?
Using the showlogs(8) Command to Reference Console Logs The XSCF firmware collects the domain console messages output through the XSCF in a console log. A console log is collected as one entry for each line feed code. In some cases, console logs may be called console message logs.