How much does it cost to get a VATS key made?
Table: Total Cost to Make a Car Keys By key Type
| Duplicate Key Cost | ||
|---|---|---|
| VATS Car Key | $ 20 | $ 35 |
| Transponder Car Key / Chip Key | $ 10 | $ 80 |
| Laser Cut Car Key (High Security) | $ 50 | $150 |
| Proximity FOBs | $ 75 | $300 |
What is GM passkey?
The PassLock system was designed to prevent vehicle theft by disabling fuel to the engine if attempts are made to start the vehicle without the correct bitted key. …
What years did GM use vats?
What is VATS? VATS (Vehicle Anti Theft System) was introduced by GM on the 1986 Corvette because the Corvette had become the number one target of car thieves. Corvette thefts dropped so impressively after VATS was implemented that GM expanded the system in 1988 to the Camaro, Firebird, and Cadillac Seville.
Can a locksmith make a car key?
Not only do auto locksmiths unlock locked cars, they can also create new keys, remove broken keys from locks, and can even replace both the locks on your car doors and entire ignition systems as well.
How can I get vats without a key?
How to find vats resistance without key?
- Use a multimeter to measure the Ohms value of the thin strip of metal on the plastic oval on the keyblade of your key.
- Choose the Resistor that most closely matches the Kilo-Ohms value of your key’s chip.
What does GM vats disable?
The VATS module controls the starter enable relay and the fuel disable parameter in the ECM. If the wrong resistance is detected, then the VATS module will NOT let the ECM power the fuel pump. It also will NOT let the starter turn.
Can GM dealer cut key Vin?
Yes a dealership can cut you a new key, but I recommend calling your local hardware store who can source you a brick to throw through the window.
What is a GM pass-key?
The Pass-Key, Pass-Key II, or VATS, as it’s called in earlier GM vehicles, uses a resistor mounted in the key blank to confirm that the correct ignition key is being used to start the engine.
What is the passkey 2 reset procedure on a Chevy?
Passkey II Reset procedure. Passkey II reset procedure, reset security system on chevy, buick, oldsmobile, cadillac, pontiac, saturn, hummer Make sure the battery if fully charged because this procedure may take up to 30 minutes and you cannot start the vehicle during this time.
Where to buy GM vats Passkey II bypass module for LS1?
Buy Timers.Shop GM VATS PASSkey II Bypass Module for LS1 and LT1 Painless: Anti-Theft – Amazon.com ✓ FREE DELIVERY possible on eligible purchases Amazon.com: Timers.Shop GM VATS PASSkey II Bypass Module for LS1 and LT1 Painless : Automotive
Do you have to relearn when replacing the PCM on Passkey?
No relearn is required on a Passkey equipped vehicle when replacing the PCM. Passkey II – The Passkey II system has the Theft Deterrent Module (TDM) function stored in the Body Control Module (BCM). The TDM portion of the BCM will validate the resistive chip in the ignition key.