How do I reset my HP V1910 24g?

How do I reset my HP V1910 24g?

Restore to factory default configuration….HP V1910-48G JE009A Factory reset – Password recovery capability enabled.

1. Connect switch cable to COM.
2. Open Putty on COM 38400 – 8 – 1 – N.
3. Powercycle the switch.
4. Press Ctrl-B at boot to enter extended boot menu.
5. Skip current system configuration.
6. Reboot.

What is the default password for HP ProCurve Switch?

The default username for first time configuration is admin, no password is required. Usernames and passwords are case sensitive. To log in to the CLI: 1. Press Enter.

How do I access the HP v1910 switch?

a. Type the IP address http://169.254.1.2 in the address bar and press Enter. The login page of the web interface appears: b. Enter the username admin and the verification code (As shown in the image below.

How do I setup my HP 24g switch 1920?

Initial configuration

1. Place the switch close to the PC that will use for configuration.
2. Connect power to the switch, and then start the PC (If it is not already running) and wait until the switch and PC have finished their start-up sequences.
3. Connect the PC to any port on the switch using a standard Ethernet LAN cable.

How do I find the IP address of my HP switch?

A switch should have a web interface and a telnet interface. Another approach would be to use the arp command to find its IP address from the Mac address (which should be physically labeled on it somewhere).

How do I reset the password on my HP ProCurve switch?

If you lose or have forgotten a switch password: Solution: You can clear the switch password by pressing the recessed Clear button on the front of the switch. This action deletes all password and user name protection from all of the switch’s interfaces.

How do I change the IP address on my HP 1920 switch?

Click on Quick Setup. In the Switch Quick Setup Parameters box, click on Change. Enter the IP address and any other information such as the Subnet mask and Gateway. Click on Save to save changes.

How do I reset my HP Deskjet 2620 to factory settings?

2620-24-PPoE+: factory default reset on the switch

1. Using pointed objects, simultaneously press both the Reset and Clear. buttons on the front of the switch.
2. Continue to press the Clear button while releasing the Reset button.
3. When the Self Test LED begins to flash, release the Clear button.