Can you use cove molding for a ceiling?

Cove Molding Smooths the sharp transition between wall and ceiling, cabinetry or stair treads — without getting too fancy. Is available in narrow widths, some as narrow as 3/4 inch, to meet various woodworking purposes.

What angle do you cut cove molding?

Cut 1/2 inch from the end of the molding at a 90-degree angle with a coping saw or a miter saw. This gives you the clean, sharp edge needed on the profile that enables you to cope it with precision.

Is there a top and bottom to cove molding?

The deeper grooves go on the bottom, and shallower grooves belong on the top. Generally, crown moulding extends further down the wall than on the ceiling. The concave (cove) side goes down, and the convex (rounded) side goes up.

Is cove molding the same as crown molding?

Cove molding performs the same function in the same place on the wall as crown molding. The main difference is the profile; cove molding has a concave profile, which bows inward, while crown molding has a convex, flatter appearance that projects out from the wall.

How do you apply Cove nail molding?

Place the trim and drive a 2-inch finish nail into the lower edge of the cove face at a 90-degree angle. Stop hammering when the head is 1/2 inch from the surface of the wood and finish driving the head below the surface with a nail set to avoid accidentally striking the trim with the hammer.

Why is there a gap between crown molding and ceiling?

Crown molding ceiling gap happens because the rough lumber behind the drywall shrinks. It can be prevented by nailing the ceiling molding to the ceiling allowing it to float up and down on the wall.

How do I install cove molding?

Installing Crown Moulding

Measure the wall again.
Cut the moulding 1/8-inch longer than measured.
Make a square cut on the uncoped end of the crown moulding.
Flex the moulding in place.
Nail or glue the moulding to the wall and ceiling.
Putty any nail holes.

How do you install cove molding?

The first step in installing cove molding is measuring to see how much molding is needed. Some people choose to match the molding to the floor or ceiling color or choose a complementary color. Start in one corner and measure the entire distance around. If the room is symmetrical,…

How to install molding?

1. Cut the pieces to the right size. Make sure all of your pieces are cut to the correct size. Following sections will give specific advice on how to

2. Locate and mark your studs. It’s best to nail molding into a stud (the internal,wooden support structure in your walls). Find and mark your studs

3. Glue the edges. When placing molding,you want to first glue the edges that will be making contact with the wall or ceiling. Don’t use too much

4. Place the piece. Once you’ve added your glue,put the piece in places and adjust it until it fits snugly. Marking where on the wall the piece needs

Can you put crown molding on angled ceiling?

Ignore the angle and just run the crown molding at the same height as the other walls – so it would just be straight across on the angled wall(s). You could then bring the ceiling color down to meet the crown molding.

What is cove molding?

Cove moldings are used where walls and ceiling meet. They have a concave profile, and for this reason, they are often used as inside corner guards, or to hide joints. Cove molding profiles are measured by the width, and then by the length of the profile.