What is iwconfig used for?
iwconfig is similar to ifconfig, but is dedicated to wireless networking interfaces. It is used to set the parameters of the network interface which are specific to the wireless operation (eg. frequency, SSID).
What does Iwlist stand for?
Iwlist is used to display some additional information from a wireless network interface that is not displayed by iwconfig(8). The main argument is used to select a category of information, iwlist displays in detailed form all information related to this category, including information already shown by iwconfig(8).
What is Iwlist scan?
iwlist. iwlist is used to scan for available wireless networks and display additional information about them that is not displayed by iwconfig. The command is primarily used to generate a list of nearby wireless access points and their MAC addresses and SSIDs.
What does iwconfig stand for in Linux?
wireless network interface
iwconfig – configure a wireless network interface.
Is iwconfig deprecated?
Resolution. The wireless-tools package which provides iwconfig has been deprecated in RHEL7. It has been replaced with iw command which comes with iw-3.10-4.
What is bit rate in iwconfig?
The bit-rate is the speed at which bits are transmitted over the medium, the user speed of the link is lower due to medium sharing and various overhead. You may append the suffix k, M or G to the value (decimal multiplier : 10^3, 10^6 and 10^9 b/s), or add enough ‘0’.
What has replaced netstat?
The replacement for netstat -r is ip route , the replacement for netstat -i is ip -s link , and the replacement for netstat -g is ip maddr , all of which are recommended instead.
What is iwconfig in Linux?
Linux iwconfig command. On Linux operating systems, the iwconfig command configures a wireless network interface. Description. Iwconfig is similar to ifconfig, but is dedicated to the wireless interfaces. It is used to set the parameters of the network interface that are specific to the wireless operation (the wireless frequency, for example).
What is iwspy interface used for?
iwspy interface [+] DNSNAME | IPADDR | HWADDR […] Iwspy is used to set a list of addresses to monitor in a wireless network interface and to read back quality of link information for each of those. This information is the same as the one available in /proc/net/wireless : quality of the link, signal strength and noise level.
How do I set up an iwspy event?
Set the low and high signal strength threshold for the iwspy event (for drivers that support it). Every time the signal strength for any of the address monitored with iwspy goes lower than the low threshold or goes higher than the high threshold, a Wireless Event will be generated.
What is iwiwlist?
iwlist – Get more detailed wireless information from a wireless interface Iwlist is used to display some additional information from a wireless network interface that is not displayed by iwconfig (8).