How do you reset the oil light on a 2012 Ford Fiesta?

How do you reset the oil light on a 2012 Ford Fiesta?

2012-2013

1. Start with the ignition switch in OFF position.
2. Simultaneously press the accelerator and brake pedals and hold them in the fully pressed position.
3. Turn the ignition to the RUN position (do not start engine)
4. Keep both pedals fully depressed for at least 20 seconds.

How do you reset the oil light on a Ford Fiesta?

To reset the oil change warning light: Turn on the ignition (not the engine). 2. Hold down the brake and accelerator for twenty seconds until the warning light goes off.

How do you reset the oil light on a 2013 Ford Fiesta?

Using Your right foot, push down the brake and gas pedals at the same time. Hold in this position for a count of 18 to 25 seconds. Flip the ignition to the off position, then back on again. At this time, the oil light should go off.

Does Ford Fiesta have an oil light?

The Ford Fiesta has two lights that indicate problems with the oil. If you see this light, you need to check the oil to confirm it’s at the proper level. The Engine Oil Next Service light indicates when it’s time to have your oil changed.

How do you turn off the change oil light?

Hold the Reset Button and Turn the Key Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.

How do I reset my Ford oil change?

To reset the oil life monitoring system do the following:

1. Switch the ignition on.
2. Fully press the accelerator and brake pedals at the same time.
3. Keep the accelerator and brake pedals fully pressed.
4. After three seconds, a message displays confirming the reset procedure is in progress.