How do you adjust the headlights on a Mazda 3?

How do you adjust the headlights on a Mazda 3?

You can adjust the headlights on your Mazda 3 by using the 10mm adjustment bolt on the backside of the headlight housing assembly. This bolt will allow the only adjustment available on the Mazda 3. Adjusting your Mazda 3’s headlights is necessary whenever you replace the housing assembly.

How do you adjust the headlights on a 2013 Mazda 3?

Use a Phillips screwdriver and look down at the green circle, you’ll see a gear like screw. Insert Phillips screwdriver, turn clockwise to raise head lights and counter clockwise to lower head lights (to keep them even you can count the revolution/turns of the screwdriver, by using the markings on the screwdriver).

How high should headlights be adjusted?

We recommend that you measure this out so the distance is accurate. This is a general distance guideline, as some manufacturers use different distances for headlight alignment. Chrysler recommends aligning headlights at 33 feet while Toyota says 10 feet. Here’s another instance where the owner’s manual comes in handy.

How do you adjust the headlights on a Dodge Caravan?

How to Adjust the Headlights in a Dodge Caravan

1. Find a level surface with a wall close by and park your Dodge Caravan 25 feet away from the wall.
2. Locate the vertical and horizontal adjustments screws near the headlight.
3. Measure from the center of the headlights to the floor and transfer the mark to the wall.

How do you adjust the headlights on a Grand Marquis?

Starting with the driver’s side headlight, locate the adjustment screws. They will be located on the top and front of the headlight. The horizontal screw will adjust the headlight from side to side. The vertical screw will adjust the headlight up and down.

How do you adjust the headlights on a 2014 Dodge Charger?

Open the hood and look in the headlight assembly to locate the two adjustment screws. On the top-center you’ll find the vertical adjustment and on the side-center the vertical. Use a screwdriver to adjust each screw until the light beam hits the intended spot. Do this for each headlight.