How long do teejet nozzles last?
Explanation: If you normally use brass nozzles for two years before replacing them, stainless steel nozzles will last eight-to-twelve years and cost less over the long term to operate.
How do you unclog a teejet nozzle?
If a nozzle becomes clogged, it is best to blow out the dirt with a soft-bristled brush or compressed air; you should never try to blow it out with your mouth or clean with wire because the orifice can easily be damaged.
What do teejet nozzle numbers mean?
These numbers refer to the flow rate in US gallons at the rated pressure of 40 PSI (approx. 3 BAR). For example, an 02 Nozzle is rated at 0.2 US gallons per hour at a pressure of 40 PSI. For example an 02 nozzle is always yellow, and an 04 nozzle is always red.
Do spray nozzles wear out?
Like any precision component, spray nozzles wear over time. Spray nozzle wear can be hard to detect. Small changes in performance can result in quality problems and wasted water, chemicals and electricity. The cost of using worn nozzles can be very significant – tens of thousands of dollars or more per year.
When should I change my sprayer tips?
Check your fan pattern versus this test pattern and replace the new tip when the fan size has collapsed 25% of its original size. And increased paint consumption is one of indication to replace new spray tip also. Tips for longer lifetime: Use a softer brush to clean your tips after everyday used.
What happens if the nozzle of the sprayer is clogged?
Distribution is interrupted. The spray tends to get “lumpy” with heavy areas and voids. Flow rates are reduced. With passages clogged, less liquid gets through the nozzle.
How do you clean a clogged pump sprayer?
Soak the nozzle of the pump sprayer in a small bowl of warm water and a squirt of dish soap. Allow the nozzle to soak for approximately 10 minutes. Rinse the nozzle with warm water and dry it with a paper towel.
How do you read a spray nozzle?
Most companies identify their flat-fan nozzles with a four or five digit number (Figure 2). The first numbers are the spray angle and the other numbers signify the discharge rate at rated pressure. For example, an 8005 has an 80 degree spray angle and will apply 0.5 gallons per minute (GPM) at rated pressure of 40 psi.