What nails do you use for metal fascia?

What nails do you use for metal fascia?

least 2” roofing nails (or 16d exterior trim nails.) Use 1 ½” roofing nails to install soffit. Use white panel nails to install aluminum fascia. Use tin snips to cut F-channel, vinyl soffit, and aluminum fascia.

Can you put nails in fascia?

It calls for 2-inch, 16-gauge, corrosion-resistant finish nails only when you are attaching fascia to double sub-fascia. Nails should not be closer than 1 1/4 inches from the edges and no nearer than one inch from the ends. With pneumatic nailing, Hardie Trim recommends driving the finish nails flush.

What fasteners to use on fascia?

What nails do you use for fascia?

• Galvanized nails.
• Aluminum nails.
• Stainless steel nails.

Where do you fasten aluminum fascia?

Begin installing aluminum fascia at the center of each length by pushing it up snug to the bottom of the soffit panels. Nail it, then work your way in both directions, driving nails every 16 in., placed about 1 in. from the top and bottom. Overlap joints 1 to 2 in.

How to install aluminum fascia on gables?

Cut along the vertical mark and install the final piece. The vertical line at the peak of the gable should be in the exact center of the gable. It will overlap the top piece of trim on the other side. Wrap the horizontal fascia boards before installing the aluminum fascia on the gables.

How do you cut fascia trim on a gable roof?

For example, if the distance from the edge of the last piece of trim to the highest point in the peak of the gable is 36 inches, add 4 inches and make a mark on a new piece of fascia trim 40 inches from the end of the trim. Do not cut the trim yet. Make a second mark 2 inches shorter than the first mark.

How do you attach aluminum trim to a gable roof?

Hold the aluminum trim along the fascia board on the gable, and make a pencil mark on the trim that matches the bottom edge of the fascia board. Cut the bottom angle of the aluminum fascia trim and put it back up, slipping the long edge of the trim beneath the metal flashing that covers the top of the gable fascia board.

How do you attach eave trim to fascia?

While eave trim must be cut and folded to fit the fascia and gable, it requires minimal angling to make a proper fit. Specific fasteners positioned between 12 and 24 inches apart secure the eave trim in place. Other applications can use 1 1/4-inch galvanized roofing nails to fasten the eave trims to the lowest roof purlins.