What causes a gas fireplace not to light?
If gas is coming out of the pilot, but it still won’t light, the spark igniter could be the problem. Alleyne says to look for and clear out any debris between the igniter and thermocouple. The pilot lighting, but not staying lit, indicates that the thermocouple is worn out, Worthen says.
Why would a gas fireplace stop working?
The thermocouple is a temperature sensor between the gas valve and the pilot light, and it will generate the electricity to ignite the gas when necessary. If the thermocouple is not screwed in properly, the fireplace won’t work. Check to make sure it is screwed in properly and placed correctly.
Why do my gas logs keep shutting off?
One of the main reasons why your gas fireplace keeps shutting down is likely due to the pilot light. Understandably, if your fire is not catching, or if the fire keeps going out, it could be due to the pilot light. This could be because there is dust or debris in the pilot light.
How do you bleed air from a gas fireplace?
While pressing the valve control knob in, press the igniter button repeatedly until the pilot ignites. This could take anywhere from one to 10 minutes to bleed air out of the lines as the gas starts to flow. Once the pilot is lit, continue to press the valve knob inward for 30 seconds before releasing it.
How do I reset my remote?
For Android TVs released in 2015 or later, symptoms may improve by updating the software of the remote control….Reset the remote control.
- Open the battery compartment cover and remove the batteries.
- Press and hold the Power button for three seconds.
- Insert the batteries again and close the battery compartment cover.
Why does my gas fireplace shut off after a few minutes?
If you get dust in the pilot assembly and the pilot needs to be cleaned out, it produces a “lazy” flame, which will be disturbed by the draught of the main burners. The flame lifts away from the thermocouple and causes the temperature on the tip of the thermocouple to drop. This, in turn, makes the gas valve shut off.
How do you clean a thermocouple on a gas fireplace?
How to Clean the Thermocouple in a Gas Fireplace
- Turn off the fireplace gas valve and remove the front panel from the fireplace.
- Find the thermocouple, which is located next to the pilot light and looks like a small straight pipe.
- Use a can of compressed air to gently blow away any dust and dirt from the thermocouple.
How do I clean the thermocouple on my gas logs?
How do I know if my thermocouple is bad on my gas fireplace?
The Fix: Pilot Light to Gas Fireplace Won’t Stay Lit So you’ve checked your pilot light and even reset it, but still, it wont stay lit. This can be an indication that your fireplace thermocouple is either bad or worn out.