How much does it cost to replace a circuit board on a hot tub?

How much does it cost to replace a circuit board on a hot tub?

Replacing a hot tub circuit board averages $350 to $1,000, depending on the make and model. The circuit board is one of the most expensive hot tub components, so this can be a costly job. It may require a lot of labor for a repairman to take the tub apart and access the area where the new board needs to be installed.

How do I know if my hot tub control panel is bad?

Spa Control Panel Displays Incorrectly

1. Error messages or error codes may indicate the problem.
2. Flickering display may indicate low voltage from transformer.
3. Partial display may indicate dirty contacts or moisture.
4. Blinking lights or flashing — indicates a system reset is needed.

How long do hot tub circuit boards last?

Don’t fret, with proper care and attention your circuit board could last as long as twenty years.

How do I test my spa control panel?

If the problem persists, turn the breaker off and disconnect the panel to examine the circuit board. Turn the power on and check if the hot tub heats up or starts to filter. The surest way to check if a control panel works is to use one you know is working and connect it to the circuit board.

How do you reset the Balboa control panel?

Remove the spa cover and allow water to cool. Once the heater has cooled, reset by pushing any button.

How do you troubleshoot a Balboa hot tub?

How to Troubleshoot a Balboa Hot Tub

1. Connect the power plug to an electrical outlet. Make sure there is electricity running to the outlet.
2. Clear out the air tubes running from the pump to the hot tub. Any debris lodged within the tube should be removed with a pipe cleaner.
3. Turn the pump on by pressing the power switch.

Where is the circuit board on a hot tub?

Most modern spas have circuit boards located inside the equipment area, commonly referred to as the “spa pack”.

How do you reset a spa controller?

1. Locate the spa’s high-limit reset. This is a red button found on many spa packs.
2. Press the high-limit reset button.
3. Turn on your spa and observe its operation.
4. Flip the breaker panel switch on or press the reset button on the GFCI outlet to restore power.