How do I unlock my Kitchenaid dishwasher control panel?

How do I unlock my Kitchenaid dishwasher control panel?

Hold the lock button for 3 seconds to unlock the control panel. Keep an eye on the red control light next to the buttons on the control panel. The light may blink 3 times before it turns off. It just means your attempt was a success!

How do I turn off the lock on my Kitchenaid dishwasher?

To turn off Control Lock, press and hold the Options key that says “Control Lock Hold 3 Sec” under it for 3 seconds. If the dishwasher has a dedicated Control Lock button in the Options selections, press and hold CONTROL LOCK for 3 seconds (press the words “Control Lock).

How do I reset my Kitchenaid dishwasher control board?

To reset the dishwasher control panel, it needs to be disconnected from the power source for one minute. If your dishwasher is plugged into an outlet, simply unplug the unit for one minute and then plug the unit back in.

How do you unlock Kitchenaid dishwasher drawer?

Press and hold the designated control lock button for your model for 3 seconds. The location of the control lock button may vary depending on your model. Refer to the Owner’s Manual for the control lock button location for your model. The light will turn off and the control will be unlocked.

How do you unlock control panel?

Steps to lock and unlock the control panel on your computer are provided below.

  1. Use Group Policy to Lock and Unlock Access to Control Panel. Type gpedit.msc on Run (Press [Windows] and [R] to open Run window)
  2. Unlock and Lock Control Panel From Windows Registry.

Why is my dishwasher stuck on lock?

Release the control lock by pressing and holding the “Control Lock,” “Heated Dry” or “No Heat Dry” key pad for three seconds. The control lock light or icon should go out. Repeat the process to set the control lock again.

How do you unlock KitchenAid dishwasher drawer?

How do you unlock a drawer dishwasher?

Closed drawer auto-lock is on Unlock by powering your DishDrawer™ back on (unless Keylock is activated, see above). Press any button and open drawer within 30 seconds.

Why does my washer say control locked?

The Control Lock feature on Front Load Washers can prevent any selections from being made when activated. The controls can be locked or unlocked after a cycle has started.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top