Are there different size U-joints?
The driveline consists of a slip yoke, the shaft, a bolt-in yoke, and two or more U-joints….U-Joint Sizes.
Series | Width | Cap Diameter |
---|---|---|
1310 Big cap | 3.219″ | Two 1.062″, Two 1.125″ |
1330 Big cap | 3.622″ | Two 1.062″, Two 1.125″ |
1350 | 3.622″ | 1.188″ |
1410 | 4.188″ | 1.188″ |
What are the dimensions of a 1310 u-joint?
Understanding U-Joints
Series | Cross Width | Cap Diameter |
---|---|---|
1310 | 3.219 (3 7/32”) | 1.062 (1 1/16”) |
1310BC* | 3.219 (3 7/32”) | 2 @1.062 (1 1/16”) 2 @ 1.125 (1 1/8”) |
1330 | 3.625 (3 5/8”) | 1.062 (1 1/16”) |
1330BC* | 3.625 (3 5/8”) | 2 @ 1.062 (1 1/16”) 2 @ 1.125 (1 1/8”) |
What is the difference between 1330 and 1350 u-joint?
They are often found in 3⁄4-ton trucks and allow more angularity than 1310 joints but are only marginally stronger. 1350 joints are found in 1-ton trucks and use the wider body of the 1330 joint but with larger trunnions and caps.
Are the front and rear U-joints the same?
Rear-wheel-drive vehicles have universal joints (or U-joints) at both ends of the drive shaft. Front-drive vehicles also use two joints, called constant velocity (or CV) joints, but they are a different kind that also compensate for steering changes.
What is a 1480 U joint?
Dana manufactures a full line of Spicer universal joints that are engineered to ensure longer life for vehicles in a wide variety of applications, from light vehicle to commercial and off-highway. …
What is a 1480 U-joint?
What is the difference between 1310 and 1350 U-joints?
Size and strength. The 1310 series joint is what you would expect to find stock in most Jeep or small trucks. A 1350 series joint/shaft is what you might find in many full size trucks. While it’s not 100% accurate, you could say that a 1310 is a “half ton” joint and a 1350 is a “one ton joint”.
What is 3r Ujoint?
This u-joint is a conversion u-joint. One side of the cross is standard 1310 series. The other side of the cross is the larger and wider 3R series….
Accessories | Gear and Axle Parts | Straight Axle Swap Parts |
---|---|---|
Bargain Bin | Rod Ends/Heim Joint Components | Used Parts Categories |
What’s the difference between a 1310 and 1350 U-joint?
What does AU joint look like?
A u-joint, or universal joint, is a component that connects the driveshaft to the differential, and sometimes connects the driveshaft to the transmission or two driveshafts to each other. It’s a cross shaped piece with a bearing at each end, that allows for lateral and side to side movement of the driveshaft.
What are U-joints connected to?
U-joints connect the driveshaft to the transmission and rear differential, and they allow for a change in the angle of the driveline. This way, the vehicle’s rear axle can move up and down without breaking the driveshaft.